Loading Paper In Paper Tray 3; Changing The Paper Size In Paper Tray 3 - Sharp MX-M700U Operation Manual

Loading paper in paper tray 3

Approximately 500 sheets of standard paper (80 g/m
can be loaded in tray 3. Special papers such as tabbed paper and transparency film can also be loaded. For
information on what special papers can be used, see "Specifications of paper trays (Types and sizes of paper that
can be used in the trays)" on page 2-12. To load tabbed paper or transparency film, see "Loading tabbed paper" or
"Loading transparency film" on the next page.
1 Pull out paper tray 3.
2 Load paper into the tray.
size, see "Changing the paper size in paper tray 3"
below.

Changing the paper size in paper tray 3

1 Pull out paper tray 3.
If paper remains in the tray, remove it.
2 Adjust the guide plates A and B by
squeezing their lock levers and sliding
them to the paper size to be loaded.
3 Load paper into the tray.
2 (20 lbs.)) from A3 to A5R size (11" x 17" to 5-1/2" x 8-1/2"R)
Gently pull the tray out
until it stops.
The paper stack must not
be higher than the
indicator line (no more
than 500 sheets of
SHARP standard paper
(80 g/m
2
(20 lbs.)).
To change the paper
The guide plates A and
B are slidable. Adjust
them to the paper size to
be loaded while
squeezing their lock
levers.
3 Gently push tray 3 into the machine.
4 Set the paper type.
If the paper size was changed from an AB size to an
inch size, or from an inch size to an AB size, or if the
paper type was changed, be sure to change the
appropriate settings as explained in "Setting the
paper type and paper size" (see page 2-14).
5 Loading paper in paper tray 3 is now
complete.
4 Gently push tray 3 into the machine.
Push the tray firmly all the way into the machine.
Set the paper type of the paper that was
5
loaded in tray 3.
Be sure to change the appropriate settings as
explained in "Setting the paper type and paper size"
(see page 2-14).
If you changed the paper size, be sure to change
the paper size setting. An incorrect paper size
setting will cause the wrong paper to be
automatically selected and may prevent printing or
cause misfeeds.
6 Changing the paper size in paper tray 3 is
now complete.
LOADING PAPER
Push the tray firmly all
the way into the
machine.
2-5
2