Sharp MX-M700U Operation Manual page 76

FINISHER AND SADDLE STITCH FINISHER
Remove the misfed paper.
11
12 Close the entrance cover of the saddle
stitch unit.
13 Turn the right-hand knob
clockwise. Then, push the left-hand knob
and turn it clockwise.
2
Remove any paper misfed on the exit side
14
of the saddle stitch unit.
15 Open the exit cover of the saddle stitch
unit and remove any misfed paper.
16 Close the exit cover of the saddle stitch
unit.
3-12
Be careful not to tear the
misfed paper during
removal.
counter
1
Be careful not to tear the
misfed paper during
removal.
Be careful not to tear the
misfed paper during
removal.
Close the lower cover of the saddle stitch
17
finisher.
18 Close the front cover of the inserter (only
when an inserter is installed).
■ When a punch module is installed
19 Open the cover of the hole punch module.
20 Rotate the green knob until the arrow is
within the range (A) on the label, and
remove the misfed paper.
(A)
Close the cover of the hole punch module.
21
22 Push the finisher back against the main
unit.
Be careful not to tear the
misfed paper during
removal.