Copying Both Sides Of A Card As Asingle Page (Card Shot) - Sharp MX-3050N User Manual

COPIER►BASIC PROCEDURE FOR MAKING COPIES
COPYING BOTH SIDES OF A CARD AS A SINGLE PAGE
(CARD SHOT)
This function copies the front and reverse sides of a card on one sheet, not on separate sheets.
This function is convenient for making copies for identification purposes and helps save paper.
Front
Back
To change the default original size during Card Shot:
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Condition Settings] → [Card Shot Settings].
Tap the [Card Shot] key.
1
► COPY MODE (page 2-3)
Select the paper to be used for card shot.
2
Set a paper by referring to the
3
Card Shot
Off
On
CA
Preview
• Tap the areas displaying width and height sizes respectively, and enter the sizes using the numeric keys.
• To quickly set the size, first specify a value close to the desired ratio value by the numeric keys, then adjust it by
tapping
• When you set the [Adjust to Paper Size] checkbox to
appropriate to the original size.
To cancel the Card Shot settings:
Tap the [Off] key.
Example of an 8-1/2" x 11" (A4)
size portrait copy
"SELECTING THE PAPER TRAY FOR COPYING (page
(1 ~ 8 1/2)
2 1/8
inch
Size Reset
(1 ~ 8 1/2)
3 3/8
inch
Adjust to Paper Size
8½x11
1
Copies
B/W
Start
.
Example of an 8-1/2" x 11" (A4)
size landscape copy
Tap the [On] key, and specify the
original size as required.
Color
Start
, the original is enlarged or reduced with the ratio
2-52
2-13)".