Loading Paper; Identifying The Trays; Loading Paper In Paper Tray 1 - Tray 2 - Sharp MX-M700U Operation Manual

LOADING PAPER

If the paper runs out during printing, a message will appear in the display.
Follow the procedure below to load paper.

Identifying the trays

The trays are identified using numbers as shown below.
For the types and sizes of paper that can be used in each tray, see page 2-12.
NOTES
● Do not use curled or folded paper. Doing so may cause a misfeed.
● Do not place heavy objects or press hard on any tray which is pulled out.
● Do not place objects on the large-capacity tray. This may damage the tray or interfere with operation.
● Load paper with the print side face up. However, when the paper type is set to "PRE-PRINTED" or "LETTER
HEAD", load the paper face down*.
* If the two-sided function is disabled using "DISABLING OF DUPLEX" in the administrator settings (page 11
of the administrator settings guide), load the paper face up.

Loading paper in paper tray 1 - tray 2

A4 or 8-1/2" x 11" size paper can be loaded in tray 1. A4 or 8-1/2" x 11" size paper can be loaded in tray 2. These
are parallel large-capacity trays that allow a total of approximately 2000 sheets of SHARP standard paper (80 g/m
(20 lbs.)) to be loaded. If you wish to change the paper size of tray 1 or tray 2, see "Changing the paper size in paper
tray 1 - tray 2" on the next page.
1 Pull out paper tray 1-tray 2.
2-2
Gently pull the tray out
until it stops.
Tray 1
1
This is the left large capacity tray.
Tray 3
2
Tray 4
3
Tray 2
4
This is the right large capacity tray.
Tray 5
5
This is an optional large capacity tray.
Bypass tray
6
2 Load paper in the left and right trays.
Indicator line
Indicator line
*1 The paper stack must not be higher than the indicator line.
2
Lift the paper guide and
load paper in tray 1.* 1
Approximately 800 sheets
of SHARP standard paper
(80 g/m
2
(20 lbs.)) can be
loaded.
Be sure to return the
paper guide to its
original position after
loading the paper.
1
Load paper in tray 2.*
Approximately 1200
sheets of SHARP
standard paper (80 g/m
2
(20 lbs.)) can be loaded.