Automatic Document Feeder; Acceptable Originals - Sharp MX-M700U Operation Manual

AUTOMATIC DOCUMENT FEEDER

The automatic document feeding function automatically feeds originals into the machine, making continuous copying
possible. In addition, both sides of two-sided sheet originals can be simultaneously scanned. This function is
convenient when you have a large number of original pages to scan.

Acceptable originals

Up to 150 originals (80 g/m
can be loaded. Originals of mixed length can also be loaded together as long as they are the same width; however,
some special functions may not operate correctly.
■ Size and weight of acceptable
originals
A5 or
5-1/2" x 8-1/2"
Original size:
(148 x 210 mm)
Weight (thickness):
2
50g/m or 14 lbs.
Special heavy papers
2
(176 (65 lbs.), 205
g/m g/m
2
g/m ... Weight of a sheet of paper of 1 m
■ Notes on use of the automatic document feeder
●Use originals within the specified size and weight ranges. Use of originals out of the specified range may cause
an original misfeed.
●Before loading originals into the document feeder tray, be sure to remove any staples or paper clips.
●If originals have damp spots from correction fluid, ink or glue from pasteups, be sure they are dried before they
are fed. If not, the interior of the document feeder or the document glass may be soiled.
●Do not use the following originals. These originals may cause incorrect original size detection, original
misfeeds, and smudges on copies.
● Transparency film, tracing paper, carbon paper, thermal paper or originals printed with thermal transfer ink
ribbon should not be fed through the document feeder. Originals to be fed through the feeder should not be
damaged, crumpled or folded or have loosely pasted paper on them or cutouts in them. Originals with multiple
punched holes other than two-hole or three-hole punched paper may not feed correctly.
●When using originals with two or three holes, place them so that the
punched edge is at a position other than the feed slot.
4-2
(20 lbs.)) of the same size, or an overall stack height of no more than 19.5 mm (49/64"),
2
A3 or
11" x 17"
(297 x 420 mm)
2
128 g/m or 42 lbs.
2
(110 lbs.)) can be used.
2
■ Total number of originals that can be
set in the document feeder tray
Maximum of 150 sheets (80 g/m
●
total stack height of 19.5 mm (49/64") or less.
Hole
positions
(20 lbs.)) or
2
Hole positions
Hole positions