Sharp MX-M700U Operation Manual page 136

SPECIAL MODES
To display the special modes screen...
See "General procedure for using special
functions" on page 5-2.
1 Touch the [TAB COPY] key in the special
modes screen (2nd screen).
SPECIAL MODES
TRANSPARENCY
COVERS/INSERTS
INSERTS
BOOK COPY TAB COPY
2 If necessary, set the image shift width (tab)
and touch the [OK] key.
OK
CANCEL OK
IMAGE SHIFT
(0 20)
10
mm
Touch the [OK] key in the special modes
3
screen.
You will return to the main screen of copy mode.
Load tabbed paper in the bypass tray.
4
tray 3, see "Loading tabbed paper" on page 2-6.
NOTE
The width of the tabbed paper can be up to A4 width
(210 mm) + 20 mm (or 8-1/2" x 11" width (8-1/2") +
5/8").
5-28
The TAB COPY setting
screen will appear. A
tab copy icon ( ) will
also appear in the
upper left corner of the
screen to indicate that
the function is turned
on.
Set the image shift
width (tab) with the
and keys.
The width can be set
from 0 to 20 mm (0 to
5/8") in increments of
1 mm (1/8").
Place the tabbed paper
so that the edges with
the tabs are the trailing
edge.
To use tab paper in tray
3, set the paper type
setting of tray 3 to "TAB
PAPER" in the tray
settings of the system
settings (page 2-14).
To load tabbed paper in
Select "TAB PAPER" for the paper type
5
setting.
The paper type setting is explained in "Setting the
paper type and paper size" (page 2-14).
If you are using tray 3, see "Setting the paper size
when a special size is loaded" (page 2-17).
About the steps that follow
If an automatic document feeder is being used,
see pages 4-7 through 4-10. If the document
glass is being used, see pages 4-11 through 4-
13.
When performing tab copying with a right
binding
If you are using left-binding tabbed paper for a right
binding, either stack the sheets in reverse order or
scan the originals in reverse order.(See the table on
the previous page.)
To cancel the tab copy function, touch the [CANCEL]
key in the tab copy setting screen (the screen of step
2).