Installation Of Options; Option Module - Ikegami HTM-1517R Operation Manual

5. Installation of Options

5-1 Option Module

<Notes>
• Modules should be inserted into the slots specified in the figure below.
• Optional modules should be inserted into the slot Nos. 2-5.
(The figure below is an example. These modules may not be installed in the product you purchased.)
• Slot 1 and Slot 6 accept the fixed modules only.
• Remove the blank panel before you mount the module.
• Fix the module securely with the two screws located at top and bottom.
• Loose screws may cause the module to come off or result in poor connector contact.
MODEL NO.
DK-801A
DKM-511A/B
DKM-511*AV
DKM-511*AVD
1 2
REMOTE
SDI
4:2:2
SERIAL CH A
PARALLEL
CH B
( )
MONITOR
OUT
DKM-511AV
4:2:2 Digital Component Module
Multi-Format Digital Module
Multi-Format Digital Module with Embedded Analog Audio output
Multi-Format Digital Module with Embedded Audio AES/EBU output
MODEL NO.
DE-801 NTSC 3 Line Comb Decoder Module
DE-811 NTSC 3/PAL-B Line Comb Decoder Module
3 4 5 6
HD/4:2:2 SDI NTSC YPbPr/RGB
CH A
CH A
INPUT
CH A
Y/G
CH B
MONITOR OUT
CH B
Pb/B
AES/EBS OUT
CH 1/2
CH 3/4
CH 5/6
CH C Pr/R
CH 7/8
AUDIO LINE OUT
SYNC
MODULE NAME
MODULE NAME
MPU Module
This module is fixed to Slot 1, and cannot be inserted to other slot.
VIDEO PROCESS Module
This module is fixed to Slot 6, and cannot be inserted to other slot.
Module fixing screws
Fix the module securely by tightening these two
screws at top and bottom.
40
SLOT WIDTH
1
1
2
2
SLOT WIDTH
1
1