Table of Contents
Advertisement
2-4. Option (CM-240 input/output)
①
CM-240
③
① Component (YPbPr/RGB) signal input
Feed component signals.
Set either YPbPr or RGB on MENU1.
When the signal format is 1080i/60 or 1035i/60,
the 1080i/1035 setting must be made on MENU1.
To select this input, set to "OPT." with the INPUT
SELECT switches ( ▲ & ▼ ) on the front panel.
Make sure that the "INPUT SELECT" on MENU10
is set at "VIDEO".
For this purpose, it is also possible to assign the
function keys [F1] and [F2] on the front panel.
2-5. Option (EA-240A output)
EA-240A
② External sync signal input
COMPONENT
Y/ G
Pb/B
Pr/R
③
PC
SYNC
②
① Embedded analog audio output
①
AUDIO OUT
(ANALOG)
- 7 -
Feed an external sync signal here when externally
synchronizing component signals.
If not adopting the loop through connection method,
connect the terminating plug.
To switch to EXT SYNC, make the setting on
MENU1.
For this purpose, it is also possible to assign the
function keys [F1] and [F2] on the front panel.
Analog PC signal input
Input the PC signal (analog RGB signal) here.
As for the compatible format, refer to the "Data 1:
PC Input Signal Compatible Format".
To select this input, set to "OPT." with the INPUT
SELECT switches ( ▲ & ▼ ) on the front panel.
Make sure that the "INPUT SELECT" on MENU10
is set at "PC".
For this purpose, it is also possible to assign the
function keys [F1] and [F2] on the front panel.
Select one pair of channels out of four paired
channels (eight embedded audio channels
multiplexed in SDI) in the MENU7. The selected
2-channel analog audio signal is outputted from
this connector.
Use XLR-5-11C or equivalent as an output
connector.
For details of pin connection, refer to the "Data 2:
Embedded analog audio outputs (EA-240A)".
The output is active. When handling the output
unbalanced, use the hot side and ground. (Keep
the cold side open.)
Advertisement
Table of Contents
