Rear Panel (Video Inputs/Outputs) - Ikegami HLM-3250W Operation Manual

2-3. Rear panel (video inputs/outputs)

①
②
③
④
① DVI-D signal input
This connector is used to connect the DVI-D signal
from the PC.
The compatible formats are referred to in "6-2
Rated performance (5)".
② SDI A/B signal input
Input the HD-SDI or SD-SDI (4:2:2) signal here.
The format of input signal is automatically
identified.
③ SDI signal output
Output the same selected channel signal from the
A/B channel as channel select is made for
monitoring.
④ NTSC/PAL-B analog composite input
Input the NTSC/PAL-B analog composite (VBS)
signal here.
Without the loop through connection in place,
connect a terminating plug.
⑤ PARALLEL REMOTE signal input
Connect the accompanying remote connector here.
For details of pin connections, refer to "Data 3:
Parallel Remote Pin Function" or "4-12.
Description of MENU 9 Functions".
Make sure the cable used is shielded.
REMOTE
PARALLEL
DVI
HD/4:2:2
SDI
CH A
SERIAL
CH B
MONITOR
OUT
VBS
CH A
CH B
⑥ SERIAL REMOTE signal input
⑦ RS-485 input/output
⑧ Analog audio input
⑨ TEST terminal for factory adjustment
- 6 -
TEST
IN
RS-485
OUT
L
AUDIO
R
Connect the BNC cable from the SRC-301A/Z serial
remote controller here.
By adopting the loop through connection, up to 99
monitors can be controlled individually or
collectively.
Without the loop through connection in place,
connect a terminating plug.
Set the monitor ID number on the MENU2 screen.
These are used for remote control with RS-485.
Up to 32 units can be loop-through-connected.
Without loop-through connection, use the optional
terminating device.
※Make sure the cable used is shielded.
Feed analog audio signals here.
The TEST terminal is factory adjustment. Connect
nothing to this terminal.
⑤
⑨
⑥
⑦
⑧