Table of Contents
Advertisement
2-3 Rear panel (video inputs/outputs)
SDI A/B signal input
3G-SDI, HD-SDI or SD-SDI (4:2:2) signals are
input through this connector.
The format of an input signal is automatically
detected to control the monitor.
SDI signal output
The signal of the channel selected on the moni-
tor is output from the A/B channel of the input
SDI signal.
* When channels are set to
LOCK on MENU2, signal is output from only
the channel set to
NTSC/PAL analog composite input
NTSC/PAL VBS (analog composite) signals are
input through this connector.
When loop-through-connections are not made, a
75 termination should be connected.
Analog audio input
Feed analog audio signals here.
Analog audio output
Select analog audio or downmix audio or one
pair of channels out of four paired channels
(eight embedded audio channels multiplexed in
SDI) in the MENU6. The selected 2-channel
analog audio signal is outputted from this con-
nector.
ON
in
SDI CH
ON .
PARALLEL REMOTE signal input
Connect the accompanying remote connector here.
For details of pin connections, refer to "D D ata 3:
Parallel Remote Pin Function" or "4 4 -11. Description
of MENU 8 Functions".
Make sure the cable used is shielded.
SERIAL REMOTE signal input
Connect the BNC cable from the SRC-301A/Z(*)
serial remote controller here.
*SRC-301A/Z is discontinuation.
By adopting the loop through connection, up to 99
monitors can be controlled individually or collec-
tively.
Without the loop through connection in place, con-
nect a terminating plug.
Set the monitor ID number on the MENU2 screen.
RS-485 input/output
This I/O is connected when performing a material
display by using the TSL UMD protocol or a TALLY
display.
Up to 32 units can be loop-through-connected.
Without loop-through connection, use the optional
terminating device.
* Make sure the cable used is shielded.
TEST terminal for factory adjustment
The TEST terminal is factory adjustment. Connect
nothing to this terminal.
- 8 -
Advertisement
Table of Contents
