Rear Panel (Video Inputs/Outputs) - Ikegami HLM-960WR Operation Manual

2-3 Rear panel (video inputs/outputs)

SDI A/B signal input
Input a 3G/HD-SDI or SD-SDI (4:2:2) signal
here.
The format of input signal is automatically
identified.
SDI C(OUT1)/D(OUT2) signal input and output
Both input and output can be set in the
"MENU-INPUT-SDI CH-C/D MODE" settings, and
10 different combinations are possible.
Input 3G/HD/SD-SDI(4:2:2) signals to this con-
nector.
Input signal format is automatically identified.
Please refer to " " 4-2. Function Description of
MENU-INPUT" for the input/output setting
items.
HDMI signal input
Input an HDMI signal (HDCP compatible) here.
Ethernet
HLM-960WR / 1760WR / 2460W
Analog audio input
Feed analog stereo audio signal here.
RS-485 connection
Monitor control is possible by connecting a serial
remote controller "SRC - 400" here.
It is possible to control "TSL UMD Protocol V3.1".
If it is not a loop-through connection, use a termi-
nator.
Set the monitor ID number within the range from
000 to 126 in "MENU-UMD/IMD-TSL MONITOR ID".
Please refer to " " 4-12. Function Description of
MENU-UMD/IMD" for the setting items.
NTSC/PAL analog composite input
Input an NTSC/PAL analog composite (VBS) signal
here.
Without the loop through connection in place, con-
nect a terminating plug.
PARALLEL REMOTE signal input
Connect the accompanying remote connector here.
Use shielded wire for the cable.
For the setting items, refer to "4-11. Function ex-
planation of MENU - P.REMOTE".
- 9 -