Installing The Rail Assemblies - NEC Express5800/120Rf-2 User Manual

Installing the Rail Assemblies

1. Align the left slide rail assembly behind the mounting holes in the vertical-
mounting rail located on the left side of the rack cabinet. The catch tabs on
the front and rear of the slide rail assembly help to align it with the holes in
the vertical-mounting rail. See Figure 2-6.
2. Install two of the large screws and washers to secure the front of the slide
rail assembly to the front vertical-mounting rail and loosely tighten them.
See Figure 2-6.
Figure 2-6. Installing the Rail Assemblies into the Rack
3. Carefully align the rear holes of the slide rail assembly with the holes in the
rear vertical-mounting rail.
4. Install two screws and washers to secure the rear of the slide rail assembly to
the vertical-mounting rail.
5. Tighten all four screws holding the slide rail assembly to the vertical
mounting rails.
6. Repeat steps 1 through 5 for the mounting the right slide rail assembly on
the right side of the rack cabinet.
Note:
to be readjusted and tightened. See Figure 2-7.
A Catch
B Screw hole for securing the server to the rack
The screws in the oblong slots of the outer slide rail may need
A
B
A
Setting Up the System 2-9