Device Installation Or Removal Procedure; 3.5-Inch Hard Disk Drive - NEC N8100-1220F User Manual

DEVICE INSTALLATION OR REMOVAL PROCEDURE

Install or remove a component from the server in the following procedure.

3.5-inch Hard Disk Drive

The 3.5-inch device bay on the front of the server contains five slots on which hard disk drives can
be installed. The device bay is not equipped with any hard disk drives (excluding when one or
more built-in hard disk drives are ordered). Purchase the hard disk drives additionally if required.
IMPORTANT:
Do not use any hard disk drives that are not authorized by NEC.
Installing a third-party's hard disk drive may cause a failure of the
server as well as the hard disk drive. Purchase hard disk drives of
the following models:
– N8150-199 (36.3GB, 15,000rpm, SAS)
– N8150-200 (73.2GB, 15,000rpm, SAS)
– N8150-201 (146.5GB, 15,000rpm, SAS)
The supported RAID level depends on the disk array controller to be
used.
– Onboard RAID:
– Optional disk array controller:
All five slots may contain a hard disk drive approximately 25.4 mm (1 inch) high.
Slot 4
RAID0, RAID1, and RAID5 (See "Disk Array Configuration" in
this chapter.)
Refer to the manual that comes with the disk array controller. (If
you purchased the board by BTO (built-to-order), the manual is
provided with the server.)
Slot 3 Slot 2
Upgrading Your Server 9-5
Slot 1 Slot 0