NEC N8100-1220F User Manual page 354

8-50 Troubleshooting
The server is not found on the network:
Is the LAN cable connected?
→ Make sure to connect the LAN cable to the network port on the rear of the server.
Also make sure that the LAN cable to use conforms with the network interface
standard.
Is BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS setup utility of the
server. Check the setting with the BIOS setup utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Embedded NIC 1], [Embedded NIC 2]>
Have the protocol and service already configured?
→ Install the distinctive network driver for the server. Make sure that the protocol,
such as TCP/IP, and services are properly specified.
Is the transfer speed correct?
→ Open the network property dialog box in control panel to specify the "Link Speed
& Duplex" value the same as the value specified for HUB.
The processor name displayed in [General] tab of [System Property] is not in correct position.
→ There is no problem for operation.
The system displays the message below and fails to log in.
→ In Windows Server 2003, the following message will be displayed if you use the
operating system without executing the license authentication. Select "Yes", and
execute the procedure for license authentication.
This copy of Windows must be activated with Microsoft before you can
Windows Product Activation
continue, You cannot log on until you activate Windows.
Do you want to activate Windows now?
To shut down the computer, click Cancel.
YES NO Cancel