NEC N8100-1220F User Manual page 328

8-24 Troubleshooting
Error
Error message
code
8130 Mismatch DIMM Type detected in DIMM group
#1.
8131 Mismatch DIMM Type detected in DIMM group
#2.
8132 Mismatch DIMM Type detected in DIMM group
#3.
8133 Mismatch DIMM Type detected in DIMM group
#4.
8134 Msmatch DIMM Type detected in DIMM group
#5.
8135 Mismatch DIMM Type detected in DIMM group
#6.
8136 Mismatch DIMM Type detected in DIMM group
#7.
8137 Mismatch DIMM Type detected in DIMM group
#8.
8140 DIMM group #1 with error is enabled.
8141 DIMM group #2 with error is enabled.
8142 DIMM group #3 with error is enabled.
8143 DIMM group #4 with error is enabled.
8144 DIMM group #5 with error is enabled.
8145 DIMM group #6 with error is enabled.
8146 DIMM group #7 with error is enabled.
8147 DIMM group #8 with error is enabled.
8150 NVRAM Cleared By Jumper.
8151 Password Cleared By Jumper.
8160 Mismatch Processor Speed detected on
Processor 1.
8161 Mismatch Processor Speed detected on
Processor 2.
8162 Mismatch Processor Speed detected on
Processor 3.
8163 Mismatch Processor Speed detected on
Processor 4.
8170 Processor 1 not operating at intended frequency
8171 Processor 2 not operating at intended frequency
8172 Processor 3 not operating at intended frequency
8173 Processor 4 not operating at intended frequency
817F All processors not operating at intended
frequency
81A0 Cache Cautionary status detected on Processor
1.
81A1 Cache Cautionary status detected on Processor
2.
81A2 Cache Cautionary status detected on Processor
3.
81A3 Cache Cautionary status detected on Processor
4.
Recommended Action
See the labels put on the DIMMs to make
sure that the DIMMs of the same type are
installed in groups. If DIMMs of different
types are installed in one or more groups,
contact the service representative to
replace DIMMs properly.
Contact your service representative to
replace the two DIMMs in the relevant
group.
Turn off the power. Then recover the
jumper setting to the original setting.
Check the frequency of the processor. If
it is unknown, contact your service
representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.