Remote Management Function; Default Network Settings - NEC N8100-1220F User Manual

4-90 Configuring Your Server

REMOTE MANAGEMENT FUNCTION

Remote Management Function enables your system to monitor the status of power supply unit, fan
and temperature of servers by BMC (Baseboard Management Controller) and a remote KVM
(Keyboard, Video, Mouse) console feature by communicating through a management LAN PORT
feature.
NOTE:
becomes resolution 1024x768 and less than refresh rate 75Hz.
Since a screen is not displayed by remote PC when a setup beyond this
is performed, please set it as less than this.
Moreover, if many numbers of colors of a screen are set up, an exact
color may be unable to be displayed by remote PC.
When your server is connected to the network where broadcasting
occurs frequently, the performance about remote control may be
affected.

Default Network Settings

When linking the management LAN port at the rear of the server to a network, refer to the following
for default settings.
Using a DHCP function, the host name in the case of performing automatic registration to
a DNS server turns into the above-mentioned host name.
Host Name: ARMCXXXXXXXXXXXX,
where the 12Xs are the MAC address of the Management Card.
When you link without a DHCP server, please access the above-mentioned IP address in
the local network which can use a default IP address "192.168.1.1."
NOTE:
an IP address, host name) by the your network environment. See "BMC
Configuration" described later for the setting method.
The screen which can be displayed by the remote KVM side
IP Address : 192.168.1.1
User Name : administrator
Password : (None)
Host Name : ARMCXXXXXXXXXXXX
For security reasons, change these default settings (Password,