Table of Contents
Advertisement
DEVICE INSTALLATION OR REMOVAL PROCEDURE
Install or remove a component from the server in the following procedure.
2.5-inch Hard Disk Drive
The 2.5-inch device bay on the front of the server contains eight slots on which hard disk drives can
be installed. The device bay is not equipped with any hard disk drives (excluding when one or more
built-in hard disk drives are ordered). Purchase the hard disk drives additionally if required.
IMPORTANT:
Do not use any hard disk drives that are not authorized by NEC.
Installing a third-party's hard disk drive may cause a failure of the
server as well as the hard disk drive. Purchase hard disk drives of
the following models:
– N8150-235 73.2GB HDD (10,000rpm)
– N8150-236 146.5GB HDD (10,000rpm)
– N8150-243 36.3GB HDD (15,000rpm)
– N8150-244 73.2GB HDD (15,000rpm)
The supported RAID level depends on the RAID Controller to be
used.
– Onboard RAID Controller:
RAID0, RAID1, RAID5, RAID6, RAID10, and RAID50 (See
"RAID System Configuration" in Chapter 4.)
– Optional RAID Controller:
Refer to the manual that comes with the RAID Controller. (If
you purchased the board by BTO (built-to-order), the manual is
provided with the server.)
Slot 0
Slot 1
Slot 2
Slot 3
Slot 4
Upgrading Your Server 9-5
Slot 7
Slot 6
Slot 5
Advertisement
Table of Contents
