NEC N8100-1220F User Manual page 69

NOTE:
The operation or utility to be started at each key entry is
described below. These operations or utilities may not always be
started.
Esc
Press Esc to display the boot menu at the end of POST. This menu
allows you to select the device to be started.
F2
Press F2 to start the BIOS setup utility. Start the utility to change
the setting of the server to that fit to the environment in which the
server is used. In general, the setting may not be particularly
changed by starting the utility excluding the case in which the
previous message accompanying by an error message appears. See
Chapter 4 for the setting procedures and features of the parameters.
F4
Press F4 to start the Off-line Maintenance Utility from the
maintenance partition. See Chapter 6 for the maintenance partition.
F12
Press F12 to run the network boot.
F1
If message "Press <F1> to resume" appears, an error is detected
during POST. See "Error messages during POST" for the
information on the messages and the proper actions against the
errors. If an error message appears, pressing F1 allows the BIOS
setup utility to be started.
7.
When a password is set in the BIOS setup utility SETUP, the screen prompting you to
enter the password appears after the normal termination of POST.
The password can be entered for up to three times. If you enter the password incorrectly
all the time, the server cannot be started. In this case, turn off the power of the server, wait
for about 10 seconds, and then turn on the power to start the server again.
IMPORTANT:
8.
Starts OS at the termination of POST.
Boot Menu
1. CD/DVD-ROM Drive
2. +Removable Devices
3. +Hard Drive
4. IBA GE Slot 0B20 v1222
5. IBA GE Slot 0B21 v1222
<Enter Setup>
Set the password only after OS is installed.
General Description 2-31