Table of Contents
Advertisement
Removal Procedure
More than one person should remove the server from the rack.
1.
After making sure that the server is off-powered, remove the power cords and all interface
cables from the server.
2.
Loosen two screws with which the cable arm is fixed to the rear of the server to remove
the cable arm from the server.
Cable arm
NOTE:
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-
3 to 1-8 for details.
Do not lift the server only by two or less persons.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Loosen the screws to unlock the arm stopper.
Setting Up Your Server 3-19
CAUTION
Screws
Advertisement
Table of Contents
Troubleshooting
