NEC N8100-1220F User Manual page 431

1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Unlock the front bezel with the security key, and remove the front bezel.
3.
Remove the memory slot cover, and remove the memory board on which the DIMMs are
to be installed.
NOTE:
To additionally install a memory board, remove one screw to
remove the blank cover from the additional slot.
IMPORTANT:
4.
Locate the DIMM socket in which you are going to install DIMMs.
5.
Fully open the levers at both ends of the socket (1) and remove the socket cover.
IMPORTANT:
To avoid damaging the lever, do not apply an excess force to the
lever.
Keep the removed blank cover for future use.
Keep the removed blank cover for future use.
Upgrading Your Server 9-57