NEC N8100-1220F User Manual page 112

4-8 Configuring Your Server
PCI Hot Plug
To install the PCI board with the PCI hot plug
Select [Advanced] - [PCI Configuration] - [Hot Plug PCI Control] -
[Minimum/Middle/Maximum*]
* The setting varies depending on the PCI board subject to the hot plug. See the table
below.
Product code
N8104-86
N8104-111
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] - [Exit Saving Changes] or [Save Changes].
To discard changes to the BIOS configuration data
Select [Exit] - [Exit Discarding Changes] or [Discard Changes].
To resume the default BIOS configuration data (may differ from factory-set value)
Select [Exit] - [Load Setup Defaults].
To save the current value as user default
Select [Exit] - [Save Custom Defaults].
To load the user-defined default
Select [Exit] - [Load Custom Defaults].
Board name
100BASE-TX Adapter
100BASE-TX Adapter
Setting Value
Minimum
Minimum