Table of Contents
Advertisement
9-16 Upgrading Your Server
Server ~ Pulling Out from the Rack Cabinet~
The server needs to be pulled out from the rack for installing/removing any components other than
the hard disk drives and power supply units.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the front bezel.
Tab
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-
3 to 1-8 for details.
Do not install the server on a rack with leaving covers removed.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
frame
CAUTION
Advertisement
Table of Contents
Troubleshooting
