Rear Access Cover
To install or remove the PCI board, or to change cable connections of internal cable, you will need
to remove the rear access cover.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Removal
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Loosen the captive screws located on the rear of the cover.
4.
Slide the rear access cover toward the rear of the chassis.
5.
Lift the cover up and off of the chassis.
Captive screw
Be sure to power off the server before removing the rear access cover.
Upgrading Your Server 9-23
CAUTION