Iq V2 - Psion Teklogix 7535 User Manual

Chapter 6: Tekterm Application

802.IQ v2

6.21.2 802.IQ v2

Important:
Port
"Port" specifies the UDP port used by 802IQ v2. The default value is 8888. Keep in
mind that the value assigned here must match the value set at the network controller.
Note: When using 802.IQ v2, make certain that the 7535/7530 "Net Mask"
matches the network controller net mask.
More Parameters
Important:
Auto Radio Addr
Radio Address
Initial RTT
Auto Radio Addr
If this parameter is set to "Y", the 7535/7530 requests an automatically assigned
radio address.
Note: If 'Auto Radio Addr' is enabled (set to "Y"), any value assigned to the
'Radio Address' parameter is ignored.
Radio Address
Important:
The value entered in the "Radio address" parameter is used to identify the
7535/7530 hand-held over the radio link. A unique value from
assigned for each hand-held.
318
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
For setup information about 802.IQ v2, refer to the "9400 and
9450 Network Controllers User Manual" and/or the "9150
Wireless Gateway User Manual".
04
802.IQ v2
Port
More Parameters
The 802.IQ radio items listed in this menu are only available to
Psion Teklogix personnel.
05
802.IQ v2 Parameters
"Radio Address" only takes effect when "Cellular" is
enabled (set to "Y").
Range
8888 see text
» see text
Range
Y Y/N
0 1 to 3840
100 500...5000
to must be
1 3840