Psion Teklogix 7535 User Manual page 320

Chapter 6: Tekterm Application
Features
Serial
06
Serial Port
Serial Out
Serial In
SI mode
SI prefix
SI suffix
SI CRC
SI Fkey
SO prefix
SO suffix
SO CRC
Serial Port
TESS print commands control the transfer of data to and from the serial and printer
ports on the 7535/7530. At the 7535/7530 computer, the value assigned at the
'Serial Port' parameter ranks which port the TESS print command will identify and
use as the first to fourth port. The allowable options are:
,
Serial 2nd Serial
Serial Out
This parameter enables serial port output fields.
Serial In
This parameter enables the serial port input fields. If enabled (set to "Y"), the TESS
application has exclusive use of the serial port. Acceptance of data in a SI field is
determined by the SI prefix and suffix.
SI mode
The possible values for this parameter are
the SI mode is set to
serial input fields. If you are using serial-input fields, make sure the "SI mode"
parameter is set to
When "SI mode" is set to
Passthrough data to the host.
Note: "Command" mode is supported by SDKs but not by emulations.
294
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
Serial
Any Available
Y
N
10
13
N
0
10
13
N
,
3rd Serial
, data received through the serial port is displayed in the
field
.
field
, data received by the serial port is transmitted as
command
Range
see text
Y/N
Y/N
see text
0..255
0..255
Y/N
0..255
0..255
0..255
Y/N
Any Available
, and
4th Serial
(the default) and
field
,
1st
.
Disabled
. When
command