Psion Teklogix 7535 User Manual page 308

Chapter 6: Tekterm Application
Kbd Modes
Xmit Enter
The <ENTER> key normally enters data into a field and moves the cursor to the
next field. However, some applications require that the <ENTER> key start a
transmission from the 7535/7530. When enabled (set to "Y"), this parameter causes
the <ENTER> key to start a transmission.
Insert
When this parameter is disabled (set to "N"), it behaves in "replace" mode –
a character entered at the keyboard or received from the host replaces the
character at the cursor position. The cursor then advances one character position.
When enabled (set to "Y"), the character entered at the keyboard or received from
the host is inserted at the cursor position after shifting the characters at and following
the cursor forward one position. The cursor is advanced one position. The extent
of the characters affected by the shift depends on the setting of the "Edit Extent"
parameter (see page 283).
Newline
When this parameter is disabled (set to "N"), an LF character received from the
host causes the cursor to move down one line in the same column. In addition,
the <ENTER> key transmits a CR. When enabled (set to "Y"), an LF character
received from the host causes the cursor to move to the first column of the next
line. The <ENTER> key transmits both a CR and an LF.
Disable kbd
Setting this parameter to "Y" disables the keyboard and scanner. When this
parameter is set to "N", the keyboard and scanner are enabled.
DEC Cursor Keys
This parameter can be set to either
Mode causes the cursor keys to generate ANSI cursor control sequences.
Application Mode causes the cursor keys to send application control functions.
282
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
or
Cursor Mode Application Mode
. Cursor