Psion Teklogix 7535 User Manual page 304

Chapter 6: Tekterm Application
Xmit Modes
Block Mode
All modes in this section affect the data stream sent to the host computer, the serial
port and the console port. These modes apply to the Block mode (Local Editing)
and the Media Copy function, unless otherwise noted. Consult the Teklogix ANSI
Terminal Programmer's Manual for more information.
Kbd lock
When this parameter is disabled (set to "N"), the 7535/7530 does not lock the
keyboard after a block mode transmission. When enabled (set to "Y"), the keyboard
is locked after a transmission. The application program must unlock the keyboard
by resetting the Keyboard Action Mode (KAM), using the Reset Mode (RM) or
Enable Manual Input (EMI) controls.
Xmit key
When this parameter is disabled (set to "N"), the key that causes the hand-held
to transmit is not sent to the host as part of the transmitted data. When enabled
(set to "Y"), the key that causes a transmission is sent after the page data has
been sent to the host. This parameter applies only to block mode.
FETM
When the Format Effector Transfer Mode (FETM) parameter is disabled (set to
"N"), Format Effectors are inserted in data sent to the host or included in data when
transferred to the console or serial ports. When enabled (set to "Y"), the Format
Effectors are not inserted into the data sent to the host and are not included in the
data transferred to the console or serial ports.
278
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
Block Mode
06
Kbd lock
Xmit key
FETM
GATM
MATM
SATM
TTM
EOL chars
EOB chars
N
N
N
N
N
Y
Y