Utilities By Serial Command; Table 12-1 Summary Of Utility Serial Commands - Microscan MS-9 User Manual

Utilities by Serial Command

Command Type
Read Rate
Counters
Device Control
Master Database
Firmware
Symbol Types
Trigger
a
Restore/Save

Table 12-1 Summary of Utility Serial Commands

Command
<Cp>
<C>
<Ce>
<J>
<T>
<U>
<V>
<W>
<N>
<O>
<X>
<Y>
<L1>
<L2>
<L3>
<I>
<H>
or
<KF> <K501>
<KF>
or
<KE> <K500>
<KE>
<#>
<E>
<F>
<Mmaster symbol
number,data>
<M#?>
<M?>
<Mmaster symbol
number,>
<!>
<!b>
<!a>
<#>
<#b>
<#a>
<P>
<Q>
<R>
<S>
<char>
<A>
<Ad>
<An>
Enter Single Symbol Percent Rate Test
Enter Single Symbol Decode Rate Test
Extended Read Rate
Exit Decode Rate and Percent Rate Test
Trigger Counter
Trigger Counter Reset
Good Read/Match Counter
Good Read/Match Counter Reset
Noread Counter
Noread Counter Reset
Mismatch Counter
Mismatch Counter Reset
Output #1 Pulse
Output #2 Pulse
Output #3 Pulse
Disable Scanner
Enable Scanner
Send Motor Off
Send Motor Off
Send Motor On
Send Motor On
Master Symbol Database Size
Enable Master Symbol
Disable Master Symbol
Enter Data to Database for Specified Symbol.
Note: <K231,#,data>
Request Master Symbol Data For Specific Symbol
does the same.
Note: <K231,#,?>
Request all Master Symbol Information
does the same.
Note: <K231,?>
Delete Master Symbol
does the same.
Note: <K231,#,>
Display Checksums of EPROM
Display Checksum for Boot Code
Display Checksum for Application Code
Display Part Number
Display Boot Code Part Number
Display Application Code Part Number
Autodiscriminate All Codes
Enable Code 39 Only
Enable Codabar Only
Enable I 2/5 Only
Serial Trigger Character
Reset (does not save for power-on)
Restore Default Settings
Restore Saved Settings
MS-9 Scanner User's Manual
Chapter 12 Utilities
Name
does the same.
12-3