Ethertalk (Appletalk) Configuration B7; To Access Ethertalk Settings At The Device - Xerox WorkCentre 7228 System Administrator Manual

EtherTalk (AppleTalk) Configuration
The EtherTalk Protocol enables workstation to Device communications over the EtherTalk (AppleTalk)
network.

To access EtherTalk Settings at the Device

1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press the System Settings button (the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press the System Settings button.
6. Press the Network Settings button.
7. Press the Port Settings button to access the Port Settings menu.
8. Press the EtherTalk selection line on the Port Settings menu.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the EtherTalk selection menu displays, note that you have only one selection available on a
single, numbered horizontal line, with the current status of this setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the horizontal
line selection, to access available settings press the Change Settings button in the lower right corner
of the touch screen.
58
B7