Setting The Network Environment; Setting The Device Ip Address (Ipv4) - Xerox DocuCentre SC2020 User Manual

3. Press the power switch to the [ | ] position to turn the power ON.

Setting the Network Environment

This section describes how to make the settings needed to use the TCP/IP protocol.
Note: The device supports IPv6 addresses in an IPv6 network environment. For more information, refer
to Setting the Device IP Address (IPv6)
Configuration on the Device
• IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
• The setting of subnet mask and gateway addresses may be required depending on the network
environment. Consult your network administrator and configure the required settings.
Configuration on the Computer
• IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
• When setting the network such as IP addresses with a host used under the Network Information
Service (NIS), consult your NIS administrator.

Setting the Device IP Address (IPv4)

To use the TCP/IP protocol, you must set the device's IP address. By default, the device is set to obtain its IP
address automatically.
This setting automatically sets the device IP address when the device is connected to a network containing
a DHCP server.
Print the System Settings Report to check whether the device IP address has already been set.
You can also check the IP address in the following methods:
• On the message field of the touch screen
• On the [About This MFP] screen
on page 32.
Environment Settings
® ®
Xerox DocuCentre SC2020
User Guide
30