Antenna Memory Settings; D Antenna Type Selection - Icom IC-7700 Instruction Manual

■ Antenna memory settings

ANT
ANT MW
F-3
D D Antenna type selection
∫ √
F-1 F-2
Band keys
ANT TYPE
F-7
ANTENNA TUNER OPERATION
This function stores the antenna connector number for
each frequency band.
q Push
EXIT/SET
screen, if necessary.
w Push and hold [ANT]
tenna set screen.
e Select the desired frequency band with a band key.
r Push [ANT]
(MF1)
antenna number that you want to set for the se-
lected frequency band.
• "★" appears.
t Push and hold [ANT MW]
the antenna selection into the antenna memory.
• "★" disappears.
y Repeat the steps e to t to store the antenna se-
lection for another frequency bands, if desired.
u Push
EXIT/SET
When no antenna is connected to [ANT2], [ANT3],
and/or [ANT4], these antenna connectors can be de-
activated — deleting the antenna number from the
available selections. This prevents the transceiver from
accidentally transmitting into an unused antenna con-
nector. In addition, a receive-only antenna can be
specified for [ANT4].
q Select the antenna set screen as described above.
w Push [ANT TYPE]
screen.
e Push [Y]
or [Z]
F-1
tenna.
r Rotate the main dial to select the desired antenna
condition from TX/RX, RX (ANT4 only) and OFF.
• TX/RX : Select when an antenna is connected.
• OFF : Select when no antenna is connected.
• RX : Select when a receive only antenna is
connected.
t Push
EXIT/SET
✔ For your information
The "OFF" antennas cannot be selected with [ANT]
switch operation, or with the antenna memory
(MF1)
setting.
When "RX" is selected for [ANT4], "1/R," "2/R" and
"3/R" selections will be added for the selection for both
[ANT] switch operation and the antenna memory
(MF1)
setting. In these selections, the antenna connected to
[ANT1], [ANT2] and/or [ANT3] will be used for trans-
mission and the antenna connected to [ANT4] will be
used for reception.
10-3
several times to close multi-function
for 1 sec. to select an-
(MF1)
several times to select the desired
for 1 sec. to store
F-3
to exit antenna set screen.
to select antenna type set
F-7
to select the desired an-
F-2
(available for the [ANT4] only)
to exit antenna type set screen.
10