Icom IC-7700 Instruction Manual page 3

PRECAUTIONS
R WARNING HIGH RF VOLTAGE! NEVER
attach an antenna or internal antenna connector during
transmission. This may result in an electrical shock or
burn.
R WARNING! NEVER
with a headset or other audio accessories at high vol-
ume levels. Hearing experts advise against continuous
high volume operation. If you experience a ringing in
your ears, reduce the volume or discontinue use.
R WARNING!
Immediately turn the transceiver
power OFF and remove the power cable if it emits an
abnormal odor, sound or smoke. Contact your Icom
dealer or distributor for advice.
R CAUTION! NEVER
unstable place (such as on a slanted surface or vi-
brated place). This may cause injury and/or damage to
the transceiver.
R CAUTION! NEVER
panel side down after lifting up the transceiver by hold-
ing rack mounting handle. This may scratch the sur-
face of the place or damage the connectors on the
transceiver's rear panel.
R CAUTION! NEVER
tings of the transceiver. This may reduce transceiver
performance and/or damage to the transceiver.
In particular, incorrect settings for transmitter circuits,
such as output power, idling current, etc., might dam-
age the expensive final devices.
The transceiver warranty does not cover any problems
caused by unauthorized internal adjustment.
R CAUTION! NEVER
cover when transmitting continuously for long periods.
The top cover may be hot.
R CAUTION! NEVER
jects protrude into the transceiver or into connectors
on the rear panel. This may result in an electric shock.
R CAUTION! NEVER
the top, rear or bottom of the transceiver.
R CAUTION! NEVER
rain, snow or any liquids.
R CAUTION! NEVER
place without adequate ventilation. Heat dissipation
may be reduced, and the transceiver may be dam-
aged.
R CAUTION! NEVER
ceiver with wet hands. This may result in an electric
shock or damage to the transceiver.
operate the transceiver
put the transceiver in any
put the transceiver's rear
change the internal set-
touch the transceiver top
let metal, wire or other ob-
block any cooling vents on
expose the transceiver to
install the transceiver in a
operate or touch the trans-
R CAUTION!
The transceiver weighs approx. 22.5
kg (50 lb). Always have two people available to carry,
lift or turn over the transceiver.
R CAUTION!
The line-voltage receptacle must be
near the transceiver and must be easily accessible.
Avoid extension cords.
DO NOT
use chemical agents such as benzine or al-
cohol when cleaning the IC-7700, as they can damage
the transceiver's surfaces.
DO NOT
push the PTT switch when you don't actu-
ally desire to transmit.
AVOID using or storing the transceiver in areas with
temperatures below ±0°C (+32°F) or above +50°C
(+122°F).
AVOID placing the transceiver in excessively dusty en-
vironments or in direct sunlight.
AVOID placing the transceiver against walls or putting
anything on top of the transceiver. This may overheat
the transceiver.
Always place unit in a secure place to avoid inadver-
tent use by children.
BE CAREFUL! If you use a linear amplifier, set the
transceiver's RF output power to less than the linear
amplifier's maximum input level, otherwise, the linear
amplifier will be damaged.
Use Icom microphones only (supplied or optional).
Other manufacturers' microphones have different pin
assignments, and connection to the IC-7700 may dam-
age the transceiver or microphone.
The LCD display may have cosmetic imperfections that
appear as small dark or light spots. This is not a mal-
function or defect, but a normal characteristic of LCD
displays.
During maritime mobile operation, keep the transceiver
and microphone as far away as possible from the mag-
netic navigation compass to prevent erroneous indica-
tions.
Turn [I/O] switch (on the rear panel) OFF and/or dis-
connect the AC power cable from the AC outlet when
you will not use the transceiver for long period of time.
For U.S.A. only
CAUTION:
Changes or modifications to this device,
not expressly approved by Icom Inc., could void your
authority to operate this device under FCC regulations.
ii