Acc Set Mode - Icom IC-7700 Instruction Manual

■ ACC set mode

ACC AF Output Level
Sets the desired audio output level, output from
[ACC1], within 0 to 100% in 1% steps.
S/PDIF Output Level
Sets the desired output level of [S/P DIF], within 0 to
100% in 1% steps. (default: 100%)
ACC MOD Level
Sets the desired audio input level for modulation from
[ACC1].
S/PDIF MOD Level
Sets the desired input level for modulation from
[S/P DIF], within 0 to 100% in 1% steps.
(default: 50%)
DATA OFF MOD
Selects the desired connector(s) for modulation input
when data mode is not in use.
DATA1 MOD
Selects the desired connector(s) for modulation input
when data 1 mode (D1) is in use.
DATA2 MOD
Selects the desired connector(s) for modulation input
when data 2 mode (D2) is in use.
• Outputs approx. 200 mV at 50% (default) setting.
• Approx. 100 mV at 50% (default) setting.
MIC,ACC
• MIC : Use the signals from [MIC].
• ACC : Use the signals from [ACC1] (pin 4).
• MIC,ACC : Use the signals from [MIC] and [ACC1]
(pin 4). (default)
• S/P DIF : Use the signals from [S/P DIF].
ACC
• MIC : Use the signals from [MIC].
• ACC : Use the signals from [ACC1] (pin 4).
(default)
• MIC,ACC : Use the signals from [MIC] and [ACC1]
(pin 4).
• S/P DIF : Use the signals from [S/P DIF].
MIC,ACC
• MIC : Use the signals from [MIC].
• ACC : Use the signals from [ACC1] (pin 4).
• MIC,ACC : Use the signals from [MIC] and [ACC1]
(pin 4). (default)
• S/P DIF : Use the signals from [S/P DIF].
12-7
SET MODE
50 %
100 %
50 %
50 %
12