Icom IC-7700 Instruction Manual page 169

■ Others set mode
SPEECH S-Level
The IC-7700 speech processor can announce fre-
quency, mode and signal level. Signal level an-
nouncement can be deactivated if desired.
(default: ON)
When "OFF" is selected, the signal level is not an-
nounced.
SPEECH [MODE] Switch
Selects the operating mode speech capability when a
mode switch is pushed; ON or OFF.
(default: OFF)
When "ON" is selected, the selected operating mode
is announced when a mode switch is pushed.
Memopad Numbers
Sets the number of memo pad channels available. 5
or 10 memo pads can be selected. (default: 5)
MAIN DIAL Auto TS
Sets the auto tuning step function for the main dial.
When rotating the main dial rapidly, the tuning step
automatically changes several times as selected.
There are 2 type of auto tuning steps: HIGH (Fastest)
and LOW (Faster). (default: HIGH)
MIC Up/Down Speed
Sets the rate at which frequencies are scanned when
the microphone [UP]/[DN] switches are pushed and
held. HIGH or LOW can be selected.
Quick RIT/∂TX Clear
Selects the RIT/∂TX frequency clearing instruction
with the switch.
CLEAR
(continued)
12-15
ON
OFF
5
HIGH
• HIGH : Auto tuning step is turned ON. Fastest tun-
ing step during rapid rotation. (default)
• LOW : Auto tuning step is turned ON. Faster tun-
ing step during rapid rotation.
• OFF : Auto tuning step is turned OFF.
HIGH
• HIGH : High speed (default; 50 tuning steps/sec.)
• LOW : Low speed (25 tuning steps/sec.)
OFF
• ON : Clears the RIT/∂TX
is pushed momentarily.
CLEAR
• OFF : Clears the RIT/∂TX
is pushed and held for 1 sec.
CLEAR
(default)
12
SET MODE
frequency when
frequency when