Disabling Alarm Traps For Transceiver Modules; Displaying And Maintaining Device Management Configuration - HP 10500 Series Configuration Manual

Task
Display the current values of the
digital diagnosis parameters on
transceiver modules.

Disabling alarm traps for transceiver modules

If you install a transceiver module that has no vendor name or a vendor name other than HP, the system
repeatedly outputs traps and logs to notify the user to replace the module. To continue to use such a
transceiver module that is manufactured or customized by HP but has no vendor information, you can
disable alarm traps so the system stops outputting alarm traps.
To disable alarm traps for transceiver modules:
Step
1. Enter system view.
2. Disable alarm traps for
transceiver modules.
Displaying and maintaining device management
configuration
Execute display commands in any view and reset commands in user view.
In standalone mode:
Task
Display device alarm information.
Display asset information.
Display system version information.
Display the system time, date, local time zone, and
daylight saving time.
Display the copyright statement.
Display CPU usage statistics.
Display CPU usage monitoring configuration.
Display historical CPU usage statistics in a chart.
Command
display transceiver diagnosis
interface [ interface-type
interface-number ]
Command
system-view
transceiver phony-alarm-disable
Command
display alarm [ slot slot-number ]
display asset-info { chassis | fan fan-id | power
power-id | slot slot-number } [ csn | custom|
department | description | location | service-date |
state ]
display version
display clock
display copyright
display cpu-usage [ slot slot-number [ cpu
cpu-number ] ]
display cpu-usage configuration [ slot slot-number [ cpu
cpu-number ] ]
display cpu-usage history [ job job-id ] [ slot
slot-number [ cpu cpu-number ] ]
179
Remarks
This command cannot display
information about some
transceiver modules.
Remarks
N/A
By default, alarm traps are
enabled for transceiver modules.