Configuring Basic Ethernet Oam Functions; Configuring Link Monitoring; Configuring Errored Symbol Event Detection - HP 6125G Configuration Manual

Task
Configuring Ethernet
OAM remote
loopback

Configuring basic Ethernet OAM functions

For Ethernet OAM connection establishment, an Ethernet OAM entity operates in active mode or passive
mode. Only an Ethernet OAM entity in active mode can initiate connection establishment. After Ethernet
OAM is enabled on an Ethernet port, according to its Ethernet OAM mode, the Ethernet port establishes
an Ethernet OAM connection with its peer port.
To change the Ethernet OAM mode on an Ethernet OAM-enabled port, you must first disable Ethernet
OAM on the port.
To configure basic Ethernet OAM functions:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Set the Ethernet OAM mode.
4. Enable Ethernet OAM on the
current port.

Configuring link monitoring

After Ethernet OAM connections are established, the link monitoring periods and thresholds configured
in this section take effect on all Ethernet ports automatically.

Configuring errored symbol event detection

Step
1. Enter system view.
2. Configure the errored
symbol event detection
interval.
3. Configure the errored
symbol event triggering
threshold.
Configuring errored frame seconds event detection
Enabling Ethernet OAM remote loopback
Rejecting the Ethernet OAM remote loopback
request from a remote port
Command
system-view
interface interface-type
interface-number
oam mode { active | passive }
oam enable
Command
system-view
oam errored-symbol period period-value
oam errored-symbol threshold
threshold-value
9
Remarks
Optional
Optional
Optional
Remarks
N/A
N/A
Optional.
The default is active Ethernet OAM
mode.
Ethernet OAM is disabled by
default.
Remarks
N/A
Optional.
1 second by default.
Optional.
1 by default.