Front Panel Display At A Glance - Agilent Technologies N8900 series Operating Manual

Front Panel at a Glance

Front Panel Display at a Glance

Output voltage and current
Connection status
Operating status
Agilent N8900 Series Operating and Service Guide
Displays the actual output voltage and current.
A = analog programming is enabled
M = the paralleled unit is configured as the master
S = the paralleled unit is configured as a slave
Indicates one of the following:
OFF = the output is off
CV = the output is in constant voltage mode
CC = the output is in constant current mode
CP = the output is limited by the power limit boundary
OV = the output is disabled by the over-voltage protection
OC = the output is disabled by the over-current protection
OT = the output is disabled by the over-temperature protection
INH = the output is disabled because of a signal from the analog control port
PF = the output is disabled because of a low voltage on the AC mains
MSP = the output is disabled by the master/slave protection
UNR = the output is unregulated
Introduction to the Instrument
17