Agilent Technologies N8900 series Operating Manual page 24

Before Installation or Use
Inspect the Unit
When you receive your power supply, inspect it for any obvious damage that may have occurred during shipment. If
there is damage, notify the shipping carrier and nearest Agilent Sales and Support Office immediately. Refer to
www.agilent.com/find/assist.
Until you have checked out the power supply, save the shipping carton and packing materials in case the unit has to be
returned. Check the list under "Items Supplied" and verify that you have received these items with your unit. If any-
thing is missing, please contact your nearest Agilent Sales and Support Office.
Check for Items Supplied
Before getting started, check the following list and verify that you have received these items with your unit. If anything
is missing, please contact your nearest Agilent Sales and Support Office.
Item
DC covers
2 position plug
4 position plug
AC plug
Bolts, nuts & washers (2
each)
Review Safety Information
This power supply is a Safety Class 1 instrument, which means it has a protective earth terminal. That terminal must
be connected to earth ground through a power source equipped with an earth ground. Refer to the
tion at the beginning of this guide for general safety information. Before installation or operation, check the power sup-
ply and review this guide for safety warnings and instructions. Safety warnings for specific procedures are located at
appropriate places throughout this Guide
Observe Environmental Conditions
Do not operate the instrument in the presence of flammable gases or fumes.
The environmental conditions of the power supply are documented under Specifications. Basically, the unit should only
be operated indoors in a controlled environment. Do not operate the unit in areas where the ambient temperature
exceeds +45 degrees Celsius. This applies for rack-mounting as well as for bench use.
Agilent N8900 Series Operating and Service Guide
Description
Safety covers for DC output terminals
Connector plug for Sharing terminals
Connector plug for Sense terminals
The two center terminals are not used
Connector plug for AC input
Hardware kit for DC output terminals
Before Installation or Use
Part Number
5003-2051
5003-2038
5003-2037
5003-2053 for 400 VAC inputs
5003-2091 for 208 VAC inputs
5003-2089 for ≥ 500 VAC out-
puts
5003-2090 for < 500 VAC out-
puts
Safety Notices sec-
23