Safety Notices - Agilent Technologies N8900 series Operating Manual

Legal and Safety Information
item" as defined in FAR 2.101(a) or as "Restricted computer software" as defined in FAR 52.227-19 (June 1987) or any
equivalent agency regulation or contract clause. Use, duplication or disclosure of Software is subject to Agilent Tech-
nologies' standard commercial license terms, and non-DOD Departments and Agencies of the U.S. Government will
receive no greater than Restricted Rights as defined in FAR 52.227-19(c)(1-2) (June 1987). U.S. Government users
will receive no greater than Limited Rights as defined in FAR 52.227-14 (June 1987) or DFAR 252.227-7015 (b)(2)
(November 1995), as applicable in any technical data.
Technical Support
If you have questions about your shipment, or if you need information about warranty, service, or technical support,
contact Agilent Technologies.

Safety Notices

The following general safety precautions must be observed during all phases of operation of this instrument. Failure to
comply with these precautions or with specific warnings or instructions elsewhere in this manual violates safety stand-
ards of design, manufacture, and intended use of the instrument. Agilent Technologies assumes no liability of the cus-
tomer's failure to comply with the requirements.
HAZARDOUS VOLTAGES All models generate voltages in excess of 60 VDC, with some
models rated at up to 1,500 VDC! Ensure that all instrument connections, load wiring,
and load connections are either insulated or covered so that no accidental contact
with lethal output voltages can occur.
General
The equipment is for industrial use. It is not applicable for IT mains supply systems.
Equipment operators are subject to all applicable safety regulations. Along with the warning and safety notices in this
manual, all relevant safety, accident prevention, and environmental regulations must also be followed. In particular,
the operators of the equipment:
Must be informed of the relevant safety requirements.
l
Must have read and understood the operating manual before using the equipment.
l
Must use the designated and recommended safety equipment.
l
Do not use this product in any manner not specified by the manufacturer. The protective features of this product may
be impaired if it is used in a manner not specified in the operating instructions.
Environmental Conditions
Environmental condition are described under
Before Applying Power
Verify that all safety precautions are taken. All connections must be made with the unit turned off, and must be per-
formed by qualified personnel who are aware of the hazards involved. Improper actions can cause fatal injury as well as
equipment damage.
4
Common Characteristics.
Agilent N8900 Series Operating and Service Guide