Pin Assignments - Agilent Technologies N8900 series Operating Manual

Analog Port Connections
Analog connections are made through the 15 pin analog connector (Type: Sub-D, D-Sub) on the rear of the unit. Use a
standard connector plug (customer-supplied) to make all connections. Remember to turn of the unit before making
any rear panel connections.
Equipment DamageThe analog interface is galvanically separated from DC output and referenced
to earth ground. Therefore never connect a ground from the analog interface to the +DC or -DC out-
puts. Use an isolated, ungrounded, programming source to prevent ground loops when using the
analog interface.

Pin Assignments

The following figure identifies the pins on the analog port.
You must provide the mating plug that for the analog connector. Use a 15-pin D-subminiature connector.
For information on using the analog functions refer to
Agilent N8900 Series Operating and Service Guide
Analog Programming.
Analog Port Connections
37