Table of Contents
Advertisement
STATus Commands
STATus:QUEStionable[:EVENt]?
Queries the
event register
events that are passed by the Operation NTR and PTR filter. Reading the Questionable Status Event register clears it.
Parameter
(none)
Read questionable status event register: STAT:QUES?
*RST has no effect on this register.
l
The value returned is the binary-weighted sum of all bits set in the register.
l
STATus:QUEStionable:CONDition?
Queries the
condition register
(unlatched) operational status of the instrument. Reading the Questionable Status Condition register does not clear it.
Parameter
(none)
Read questionable status condition register: STAT:QUES:COND?
The condition register bits reflect the current condition. If a condition goes away, the corresponding bit is cleared.
l
*RST clears this register, other than those bits where the condition still exists after *RST.
l
The value returned is the binary-weighted sum of all bits set in the register.
l
STATus:QUEStionable:ENABle < value >
STATus:QUEStionable:ENABle?
Sets and queries bits in the
enabling specific bits from the Operation Event register to set the QUES (questionable summary) bit of the Status Byte
register. STATus:PRESet clears all bits in the enable register.
Parameter
A decimal value that corresponds to the binary-
weighted sum of the bits in the register.
Enable bit 2 and 4 in the questionable enable register: STAT:QUES:ENAB 24
*CLS does not clear the enable register, but does clear the
l
88
for the
Questionable Status
<bit value>
for the
Questionable Status
<bit value>
enable register
for the
Questionable Status
group. This is a read-only register, which stores (latches) all
Typical Return
group. This is a read-only register, which holds the live
Typical Return
group. The enable register is a mask for
Typical Return
<bit value>
event
register.
Agilent N8900 Series Operating and Service Guide
Advertisement
Table of Contents
