Using Telnet - Agilent Technologies N8900 series Operating Manual

Remote Interface Configuration
1. Open the Web browser on your computer.
2. Enter the instrument's hostname or IP address into the browser's Address field. The following home page will
appear.
3. Click on the Browser Web Control button in the navigation bar on the left to begin controlling your instrument.
4. For additional help about any of the pages, click on the Help with this Page button.
HAZARDOUS VOLTAGES All models generate voltages in excess of 60 VDC, with some
models rated at up to 1,500 VDC! Ensure that all instrument connections, load wiring,
and load connections are either insulated or covered so that no accidental contact
with lethal output voltages can occur.
If desired, you can control access to the Web interface using password protection. As shipped, no password is set. To set
a password, click on the View & Modify Configuration button. Refer to the on-line help for additional information about
setting a password.

Using Telnet

In an MS-DOS Command Prompt box type: telnet hostname 5024 where hostname is the instrument's hostname or
IP address, and 5024 is the instrument's telnet port.
You should get a Telnet session box with a title indicating that you are connected to the power supply. Type the SCPI
commands at the prompt.
50 Agilent N8900 Series Operating and Service Guide