Agilent Technologies N8900 series Operating Manual page 109

Reset State (*RST)
Reset State (*RST)
The power-on/reset state may differ from that shown below if you have enabled power-on state
recall mode from the States menu (see
The following tables show the reset state. These parameters are reset to the indicated values at power-on or after
*RST.
Reset Settings
SCPI Command *RST Settings
CALibrate:STATe
CURRent
CURRent:MODE
CURRent:PROTection:DELay
CURRent:PROTection:STATe
CURRent:TRIGgered
DISPlay
OUTPut
TRIGger:TRANsient:SOURce
VOLTage
VOLTage:MODE
VOLTage:PROTection
VOLTage:TRIGgered
The following table shows the as-shipped settings of the non-volatile parameters. These are not affected by power cyc-
ling or *RST.
Non-Volatile Settings
SCPI as-shipped settings
CALibrate:DATE
CALibrate:PASSword
OUTPut:PON:STATe
Front Panel as-shipped settings
Firmware update password protected
108
Instrument State
OFF
0
FIXed
50 ms
OFF
0
ON
OFF
BUS
0
FIXed
120% of rating
0
empty string
0
RST
Disabled
Agilent N8900 Series Operating and Service Guide
Storage).