Creating A Vsan; Configuring A Trunk Vsan; Displaying And Maintaining Vsan; Vsan Configuration Example - HP 6125XLG Configuration Manual

Creating a VSAN

Initially, only the default VSAN (VSAN 1) exists. You cannot create or delete VSAN 1. You can create
VSANs 2 to 3839.
On a device, you can create up to 16 VSANs, including the default VSAN.
To create a VSAN:
Step
1. Enter system view.
2. Create a VSAN and enter VSAN view.

Configuring a trunk VSAN

A VFC interface can be assigned to multiple VSANs as a trunk port.
If you assign an interface to VSANs as a trunk port multiple times, the final trunk VSAN list is the set of
all the VSANs to which you have assigned the interface.
To assign a VFC interface to the specified VSANs as a trunk port:
Step
1. Enter system view.
2. Enter VFC interface view.
3. Assign the VFC interface to
the specified VSANs as a
trunk port so that the
interface allows the specified
VSANs to pass through.

Displaying and maintaining VSAN

Execute display commands in any view.
Task
Display the member ports of the VSAN.

VSAN configuration example

Network requirements

As shown in
Command
system-view
interface vfc interface-number
port trunk vsan vsan-id-list
Figure 16, configure the SAN to meet the following requirements:
Command Remarks
system-view N/A
By default, only the default VSAN
vsan vsan-id
(VSAN 1) exists.
Command
display vsan [ vsan-id ] port-member
48
Remarks
N/A
N/A
By default, a VFC interface does not
belong to any VSAN as a trunk port.
You assign a VFC interface to a
VSAN that does not exist as a trunk
port.