Configuring The Lsr Retransmission Interval For Interfaces; Disabling Fspf For An Interface - HP 6125XLG Configuration Manual

NOTE:
The configured dead interval must be greater than the hello interval and must be the same at the two ends
of the link.
To configure the interface dead interval:
Step
1. Enter system view.
2. Enter VFC interface view.
3. Configure the dead interval for
the VFC interface in a specified
VSAN.

Configuring the LSR retransmission interval for interfaces

The LSR retransmission interval specifies the time to wait for an LSR acknowledgement from the neighbor
before retransmitting the LSR.
To configure the LSR retransmission interval:
Step
1. Enter system view.
2. Enter VFC interface view.
3. Configure the LSR retransmission
interval for the VFC interface in
a specified VSAN.

Disabling FSPF for an interface

With FSPF enabled, an interface can participate in SPF calculation. To avoid SPF calculations on an
interface, disable FSPF on the interface.
To disable FSPF on an interface:
Step
1. Enter system view.
2. Enter VFC interface view.
3. Enable FSPF for the VFC
interface in a specified VSAN.
Command
system-view
interface vfc interface-number
fspf dead-interval value vsan
vsan-id
Command
system-view
interface vfc interface-number
fspf retransmit-interval value
vsan vsan-id
Command
system-view
interface vfc interface-number
fspf silent vsan vsan-id
61
Remarks
N/A
N/A
The default setting is 80 seconds.
Remarks
N/A
N/A
The default setting is 5 seconds.
Remarks
N/A
N/A
By default, FSPF is enabled on all
VFC interfaces.