Verifying The Configurations - HP 6125XLG Configuration Manual

Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchC-vsan1] quit
# Create interface VFC 2, and configure it to operate in E mode.
[SwitchC] interface vfc 2
[SwitchC-Vfc2] fc mode e
# Bind interface VFC 2 to interface Ten-GigabitEthernet 1/1/6, and assign it to VSAN 1 as a trunk
port.
[SwitchC-Vfc2] bind interface ten-gigabitethernet 1/1/6
[SwitchC-Vfc2] port trunk vsan 1
[SwitchC-Vfc2] quit
# Assign interface Ten-GigabitEthernet 1/1/6 to VLAN 10 as a trunk port.
[SwitchC] interface ten-gigabitethernet 1/1/6
[SwitchC-Ten-GigabitEthernet1/1/6] port link-type trunk
[SwitchC-Ten-GigabitEthernet1/1/6] port trunk permit vlan 10
[SwitchC-Ten-GigabitEthernet1/1/6] quit
# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.
[SwitchC] vlan 10
[SwitchC-vlan10] fcoe enable vsan 1
[SwitchC-vlan10] quit
# Configure two static routes.
[SwitchC] vsan 1
[SwitchC-vsan1] fc route-static 010000 8 vfc 2
[SwitchC-vsan1] fc route-static 020000 8 vfc 2
[SwitchC-vsan1] quit

Verifying the configurations

# Display the FC routing table in VSAN 1 on Switch A.
[SwitchA] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Destination/mask
0x020000/8
0x030000/8
0xfffc01/24
0xfffffa/24
0xfffffc/24
0xfffffd/24
# Display the FC routing table in VSAN 1 on Switch B.
[SwitchB] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Destination/mask
0x010000/8
0x030000/8
0xfffc02/24
Routes : 6
Protocol Preference
STATIC 10
STATIC 10
DIRECT 0
DIRECT 0
DIRECT 0
DIRECT 0
Routes : 6
Protocol Preference
STATIC 10
STATIC 10
DIRECT 0
66
Cost Interface
0 Vfc1
0 Vfc1
0 InLoop0
0 InLoop0
0 InLoop0
0 InLoop0
Cost Interface
0 Vfc1
0 Vfc2
0 InLoop0