Configuration Considerations; Configuration Procedure - HP 6125XLG Configuration Manual

Figure 23 Network diagram
Server A
FC_ID:
010001
Server B
FC_ID:
010002
Server C
FC_ID:
010003

Configuration considerations

To meet the preceding requirements, divide VSAN 1 into three zones as follows:
• Zone 1 consists of Server A.
Zone 2 consists of Server B and Disks A, B, and C.
•
Zone 3 consists of Server C and Disks B and C.
•
Configure Switch A and distribute the full zone database to Switch B:
Create zone alias Alias 1, which consists of Disks B and C, to simplify the configuration.
•
Create zone set Zoneset 1, which consists of Zones 1, 2, and 3, and activate it.
•

Configuration procedure

Configure Switch A only.
If the FCF switch is connected to a server or storage device with a CNA, you must also configure DCBX
on the connecting Ethernet interface. For information about configuring DCBX, see Layer 2—LAN
Switching Configuration Guide.
For information about configuring physical-to-VFC interface bindings and VLAN-to-VSAN mappings, see
"Configuring a VFC
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A. (Skip
this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode. Enter the view of VSAN 1.
<SwitchA> system-view
Zone 1
Switch A
Zone 2
Zone 3
interface" and "Enabling FCoE for a VLAN and mapping a VSAN to the
Switch B
Alias 1
83
Disk A
PWWN:
11:22:33:44:55:66:77:88
(FC_ID:020006)
Disk B
PWWN:
22:33:44:55:66:77:88:99
(FC_ID:020005)
Disk C
FC_ID:
020004
VLAN."