Configuring The Default Fc4 Information For A Node; Displaying And Maintaining A Fabric - HP 6125XLG Configuration Manual

Step
1. Enter system view.
2. Enter VSAN view.
3. Enable auto discovery of
SCSI-FCP information.

Configuring the default FC4 information for a node

If a node does not register FC4 information and the switch fails to obtain SCSI-FCP information from the
node, the switch records the default FC4 information in the name service database for that node. When
a node registers FC4 information or the switch obtains the SCSI-FCP information, the switch replaces the
default FC4 information with the registered FC4 information or obtained SCSI-FCP information.
The fc wwn default-fc4-type command can be used to configure only one combination of FC4-Type and
Feature at a time.
To configure the default FC4 information for a node:
Step
1. Enter system view.
2. Configure the default
FC4 information for a
node.

Displaying and maintaining a fabric

Execute display commands in any view.
Task
Display the domain information of the specified
VSAN.
Display the list of domain IDs dynamically allocated in
the specified VSAN.
Display fabric timers.
Display node login information.
Display the SCR table for an N_Port.
Display name service database information.
Display ESS negotiation results.
Command
system-view
vsan vsan-id
fc name-service auto-discovery
Command
system-view
fc wwn wwn-value default-fc4-type
{ type-value feature feature-map |
scsi-fcp feature { feature-map | both |
initiator | target } }
Command
display fc domain [ vsan vsan-id ]
display fc domain-list [ vsan vsan-id ]
display fc timer [ distributed-services | error-detect |
resource allocation ] [ vsan vsan-id ]
display fc login [ vsan vsan-id ] [ count ]
display fc scr-table [ vsan vsan-id ]
display fc name-service database [ vsan vsan-id [ fcid
fcid ] ] [ verbose ]
display fc ess [ vsan vsan-id ]
31
Remarks
N/A
N/A
By default, auto discovery of
SCSI-FCP information is enabled.
Remarks
N/A
By default, no default FC4
information is configured.