Static Fabric Building Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

Static fabric building configuration example

Network requirements

As shown in
Figure 14 Network diagram

Configuration procedure

1. Configure Switch A:
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.
(Skip this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode, and disable the fabric configuration function in
VSAN 1.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 1
[SwitchA-vsan1] undo domain configure enable
# Configure a fabric name.
[SwitchA-vsan1] fabric-name 11:11:11:11:11:11:11:11
# Configure the domain ID as 1.
[SwitchA-vsan1] domain-id 1 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchA-vsan1] quit
# Enable LLDP globally.
[SwitchA] lldp global enable
# Enable LLDP on interface Ten-GigabitEthernet 1/1/5, and enable the interface to advertise
DCBX TLVs.
[SwitchA] interface ten-gigabitethernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] lldp enable
[SwitchA-Ten-GigabitEthernet1/1/5] lldp tlv-enable dot1-tlv dcbx
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Create an Ethernet frame header ACL numbered 4000, and configure two rules to match FCoE
frames (protocol type 0x8906) and FIP frames (protocol type 0x8914).
Figure 14, use the static method to build a fabric.
32