Configuration Procedure - HP 6125XLG Configuration Manual

Figure 25 Network diagram

Configuration procedure

Configuring Switch A
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A. (Skip
this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in NPV mode. Create VSAN 1.
<SwitchA> system-view
[SwitchA] fcoe-mode npv
[SwitchA] vsan 1
[SwitchA-vsan1] quit
# Enable LLDP globally.
[SwitchA] lldp global enable
# Enable LLDP on interfaces Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6, and enable
the interfaces to advertise DCBX TLVs.
[SwitchA] interface ten-gigabitethernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] lldp enable
[SwitchA-Ten-GigabitEthernet1/1/5] lldp tlv-enable dot1-tlv dcbx
[SwitchA-Ten-GigabitEthernet1/1/5] quit
[SwitchA] interface ten-gigabitethernet 1/1/6
[SwitchA-Ten-GigabitEthernet1/1/6] lldp enable
[SwitchA-Ten-GigabitEthernet1/1/6] lldp tlv-enable dot1-tlv dcbx
[SwitchA-Ten-GigabitEthernet1/1/6] quit
# Create an Ethernet frame header ACL numbered 4000, and configure two rules to match FCoE frames
(protocol type 0x8906) and FIP frames (protocol type 0x8914).
[SwitchA] acl number 4000
[SwitchA-acl-ethernetframe-4000] rule permit type 8906 ffff
[SwitchA-acl-ethernetframe-4000] rule permit type 8914 ffff
[SwitchA-acl-ethernetframe-4000] quit
90